1, conventional winding wiring method
The first common practice is to use two wires to entangle the copper wires. Remember to leave the end and buckle it. This will ensure that the connector of the wire will not be ignited, short-circuited or poorly contacted. I believe this step, many people who are not electricians know.
Note: There should be no joints in the home decoration, especially in the online tube, and there should be no joints. If there is a joint, it should be in the electric box. The usual wire joints are such a connection to ensure that the wire joints do not cause ignition, short circuit, and poor contact.
If you want to use this method, then each wire end must be treated like this in order to effectively avoid the risk of electric shock, and also to see if the master is working professionally. Here you must remind everyone that when you are at home, do not have Connectors, especially online management, if there is a connector, it should also be in the wire box.
2, fireproof tape method
This method is used less often, and is generally used in spotlights in ceilings. It should be noted that the main line cannot be broken, and the secondary wire is wound around the main line for 6-8 turns. After that, it is wrapped with fireproof tape outside, which can effectively prevent the wire from burning and burn the outer edge of the outer edge to prevent short circuit at the wiring.
If the wire joint is not wrapped with insulating tape, the wire will be exposed, which will easily cause electric leakage and even electric shock. Therefore, it must be wrapped with insulating tape to prevent leakage.
3, crimping cap connection method
Pressure line is a small tool specially used for wire connection, which is very practical and safe. The most standard and simple to use this method, the matching crimping cap and pliers are required for wiring. It is very important to select the matching crimping cap according to the square of the connected wires. When wiring, press the crimping tool with a crimping wire to press the wire, and put the special pliers for the piezoelectric wire on the pressure wire, and press it firmly. Here to tell you a little, generally use a set of wires do not use insulating tape.
In addition, we must also say that the size of the pressure line is related to the number of roots according to the size of the line. We usually use the T4 type, which is a millimeter in diameter and can press four wires of four square millimeters.
DB25 Female Connector, DB25 Male Connector,DB9 Male Connector,DB9 Female Connector,DB9 Right Angle Backshell,Molded D-Sub Cables
The On-site injection molding enables us to custom mold your D-Sub assemblies to your specs with logos. We are tooled for:
DB9 molded cables,,DB25 molded cables, DB50 molded cables, HD15 molded cables
DB Backshell or Boot-Kit Cables: The backshell cans and boot-kits are available for D-Sub DB15 cablesD-Sub DB37 cables.
Backshells are offered for: D-Sub high-density HD26, HD44, HD62, HD78
D-sub cable, DB cable, 9pin DB cable, molded DB connector, Data Cable
ETOP WIREHARNESS LIMITED , https://www.wireharness-assembling.com