How is the jaw crusher formed? - Huaqiang Electronic Network

How is the jaw crusher formed?
Below we analyze this problem, as follows:
1) The jaw crusher structure mainly includes frame, eccentric shaft, large pulley, flywheel, moving jaw, side guard, bracket, bracket rear seat, gap screw, return spring, fixed jaw and movable jaw. The composition, in which the brackets also serve as an insurance, is an important equipment insurance component. These parts are integrated to form the main body of the jaw crusher and inspected.
2) The crushing mode is a curved extrusion type. The motor drives the belt and the pulley. The eccentric shaft moves the movable jaw up and down. When the moving jaw rises, the angle between the bracket and the moving jaw becomes larger, thus pushing the moving jaw to the fixed jaw. The plate is close, and at the same time, the material is crushed, smashed, milled, etc.; when the moving jaw goes down, the angle between the bracket and the moving jaw becomes smaller, and the moving jaw leaves the fixed plate under the action of the tie rod and the spring. At this time, the crushed material is discharged from the lower mouth of the crushing chamber, and the motor is continuously rotated to crush the mobile unit for periodic crushing and discharging, thereby realizing mass production.
3) The instrument is mainly composed of iron plates and steel plates, so the quality is heavier and the freight needs to be determined according to the location.