Throughout the entire LED industry chain, from chip to packaging, finished products, no need to test the various photoelectric indicators of the product, all test procedures are carried out under the premise that the LED is powered on.
However, almost all LED product manufacturers, LED test system integrators and LED certification companies pay great attention to the entire test system, but few people pay attention to the most basic test instrument power supply. In the entire LED test system, the power supply is the most basic power supply device, and its function is not only as simple as power supply.
Suppress surges and protect LEDs
After in-depth research and analysis, it is found that when the LED test is performed using a common power supply, the average life of the LED will be reduced by 20-30% after the test is completed. The most immediate problem caused by the unintentional decline in product life during the test is that the downstream manufacturer cannot pass the aging verification of the product.
In the investigation of the LED industry, many manufacturers were plagued by this problem. They constantly suspected that their test equipment had serious deviations, and even sent technicians to the client for on-site verification, which could not solve this problem. Who can think of it? The competition is caused by the power supply. In this regard, the researchers have proposed a simple and effective solution, using advanced technology to improve the function of the DC power supply, to achieve the effect of suppressing the inrush current, thus protecting LED.
Connect the LED lightbar to the IT6200 series DC power supply, turn on the power output in normal mode and LED mode, and supply power to the lightbar. Under the condition that the current command is set to Iset=20mA, the current waveforms captured by the oscilloscope are respectively As follows:
As can be seen from the figure, when the LEDmode is selected for testing, the current of the IT6200 DC power supply series rises very smoothly to the set value at startup, and there is no surge current generated, so it will not affect the life of the LED product. .
This figure also explains from the side why the ordinary power supply will reduce the life of the LED product during the test, and as the test current increases, the surge current generated by the ordinary power supply will also increase. Therefore, the use of scientific research personnel IT6200 series DC power supply in LED related tests is the best choice.
Improve test efficiency
LED products often work in high-voltage, low-current environments, especially for products such as LEDbacklight, which typically use extremely small currents for testing. Ordinary power supplies can easily enter the current limit mode at a small current output, resulting in a delay in voltage rise time.
The smaller the current and the higher the voltage, the longer the corresponding rise time. Researchers IT6200 series DC power supply, with another unique test mode lowcurrentmode, can solve this problem. In this mode, the IT6200 series power supply can be started with a small current and the voltage rises at a high speed. When this mode is turned on, the rise time of the output voltage is not changed by the magnitude of the microcurrent, which greatly speeds up the voltage rise time and shortens the time during which the LED product is lit, thereby improving test efficiency and productivity.
Nano atomization, the desktop will not be wet when humidified, and the water molecules are refined into fine particles, which are more easily absorbed by the skin. Touch button operation, press once to continuously emit fog, press twice to intermittently emit fog, different modes have different experiences. Intelligent power-off design, automatic power-off protection for water shortage, prevent dry burning, and use more assured.
Home Humidifier,Air Evaporative Humidifier,Home Ultrasonic Air Humidifier,Portable Whole House Humidifier
Guangdong Aiyimi Electronic Technology Co., Ltd. , https://www.nbminifan.com